Lanier LP 036c Bedienungsanleitung PDF herunterladen (Seite 83)

Operating Instructions Client Reference

❖

❖❖

❖ When connecting with IEEE 1394

• The printer must be connected to the IEEE 1394 connector of a computer using the IEEE 1394

interface cable.

• [Activate] is selected in the SCSI print of IEEE 1394 and [Activate] is selected in the Bidi-SCSI

print.

• Under Windows 2000, [Enable bidirectional support] must be selected and [Enable printer pool-

ing] must not be selected on the [port] tab with RPCS printer driver.

❖

❖❖

❖ When connecting with USB

The printer must be connected to the USB connector of a computer using the USB interface cable.

-Inactivating the Device

❖

❖❖

❖ If you do not want to install the printer when [Found New Hardware Wizard] starts with an op-

erating system, which supports SCSI print, inactivate the device by following the procedures.

• Windows 2000

A In [Found New Hardware Wizard] dialog box, and then click [Next>].

B When the [This wizard will complete the installation for this Device: Unknown] message ap-

pears, and select [Search for a suitable driver for my device [recommended]], and then click

[Next>].

C When the [Locate Driver Files] message appears, remove all the selections from [Optional

search locations.], and then click [Next>].

D When the [Driver Files Search Results] message appears, select the [Disable the device. The

Add/Remove Hardware Wizard in the control Panel can be able to complete the driver installa-

tions.] check box, and then click [Finish].

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 254 255

Keine Kommentare

Lanier LP 036c Bedienungsanleitung Seite 83